Tips for Setting Up Your Outdoor Motion Sensor Lights

A few good tips for setting up your outdoor motion sensor lights will help you to avoid some of the most common errors when placing and adjusting your motion sensor units. Safety and security are two very good reasons to install motion detector lights. They will help you get into your home when arriving after dark and give you a sense of security when you’re sleeping. This kind of comfort truly is priceless so all things considered, motion detectors are a really good investment.

Motion detector lighting can be used to illuminate a walkway or driveway. It can turn on lights either inside or outside. Installing Outdoor LightThey can deter a potential intruder who may be looking for an easy mark. If your home lights up like a Christmas tree when someone approaches, its most likely the culprit will just move on to an easier mark. Safety comes when there’s no need to get out of your car in the dark. Your approach is well lit and falls can be eliminated especially in inclement weather when slippery conditions exist. Installing motion detector lighting solves several problems with one easy fix.

 

Where To Install Motion Detector Lighting

Automatic lighting is normally used to illuminate a drive or walkway. Some will use this type of apparatus to light up a back yard. Other uses include turning on interior lights when dusk arrives. This application will give the appearance that someone is home when in fact you may be away on vacation or just out for an evening. Whatever the reason for your lighting here are a few easy tips for setting up your outdoor motion sensor lights.

Start by surveying just what you need to light up. Some will need a wide beam of light to include an entire backyard for example. Others will want a narrow long beam for lighting a walkway. Driveways may require a flood light and still another type would be a wall hung sconce light for walks and entrance ways.

Your lighting apparatus will have several adjustments that must be taken into consideration when purchasing the units. You’ll need to have some sort of plan laid out on paper and a list of how many lights and where they will be located. Another question to think about will be whether or not the unit will contain the sensor that operates it or will you need a remote sensor. The proper positioning of the sensor is imperative to a good functioning motion detector lighting system. Set up your lighting and place the sensors at their highest settings. Use the test switch to operate the lights during daylight hours. This will allow you to get the settings close enough to come out and fine tune everything when it’s dark. Almost all units have adjustable timers. Normally they can be adjusted from one minute to twenty minutes or more. Figure out how long it takes you to get to where you no longer need light from when you trigger the motion detector and that should be your setting.

If you have problems with your units picking up motion from a source you don’t want them to see, such as traffic going by or even trees blowing in the wind that can sometimes effect the operation. There are tricks to help like placing a small piece of tape over the very edge of the sensor’s eye. This can reduce the peripheral vision of the unit and block out say, road traffic or a flag waving in the vision field. This can also be accomplished with a black Sharpie to a fine degree. If you have exterior lighting that isn’t under an eave or somehow protected from the elements. Make sure these light fixtures are facing down. Although most units for exterior lighting are supposed to be sealed from the weather, there is a potential problem if they are tipped up and water collects in the socket.

These tips for setting up your outdoor motion sensor lights will hopefully get you the safety and peaceful nights you’re looking for from this type of a system. Your security matters and motion lights can help in a variety of ways.

Comments are closed.